Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

2012 ford fusion Module won't program

0 votes
I just installed evo all  for1 on a 2012 ford fusion . Connected can high/ can low, immobilizer, and ignition t harness. Flashed module, followed the program instructions and can't get it to program.
asked Jan 25 in Ford by Cody Long (130 points)

1 Answer

0 votes
What is the S/N to the module?

 

What step in the programming is not working for you?
answered Jan 26 by Derek (227,910 points)
Sn  001a07029791 .
After i remove the second key and hit the program button , the light doesn't flash.
The red light blinks once when i hit it and it stays steady red. Thanks
The firmware and options look good.

 

Since you are using an FORT1, What did you connect to the yellow, lt.blue & lt.blue/black wires on the 20 pin connector of the evo?
...