Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

'21 Manual Miata cranks, but doesn't start

0 votes
I own a 2021 Mazda MX5 Miata RF GT in a manual transmission. I'm using the EVO-ONE with the THAR-ONE-MAZ3 T-Harness. I've made sure to splice the white cable (Manual only) with the corresponding white pin A5 on the 20 pin connector for the clutch bypass .I've actually gone through a couple configurations and at this point, I chose to use suggested settings as well as the settings the manual insisted. I've also enabled 3x OEM lock since I want to use my own remote. So far, once I initiate the ready mode sequence, I triple click the lock button and the car cranks for a bit but doesnt start. I've been through the settings a couple of times over to check everything and its not clear to me what might be causing it. Please let me know if there is any additional wiring needing to be done or a certain setting that's causing it not to work. I'm so close to a successful start, yet so far.
asked Mar 11, 2022 in Mazda by Rohaan Arshad (160 points)

1 Answer

0 votes
For this vehicle to crank and not start means this module is not correctly programmed and dcrypted. It has been suggested to you via email to have a profesional shop/installer go over your installation and programming. since this is a manual transmission vehicle.

Any wrong connectiosn/settings/modification may cause this vehicle to start in gear and cause injury/damage  to property.
answered Mar 11, 2022 by JM (61,780 points)