Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Car will not start

0 votes

Subaru Legacy 2013

the installation and programming went well. All wires soldered and taped. Programmed the Dcryptor program no problem. Installed it back in did the set up on the remote start and never started but caused the engine light to come on. I'm using a RS370 EXCALIBUR remote start. I did the learn set up with the remote start it went well but the car never started but tried 3x the brake peddle never shut it off very strange 

sn 001A07093213 

asked Jun 15, 2020 in Subaru by skylinewindowtinting (570 points)

1 Answer

0 votes
Are you wire to wire between the 2 units or are you using the data link? If you are using the data link what is the default protocl for your RS370?


A test to try is as follows:

- Connect only the red connector to the evo. leave all other connectors unplugged form the evo-all.


- Place key infront of ignition barrel and see if it will remote start.


If it does not start the problem lies with your remote starter and how you installed it.
answered Jun 15, 2020 by Derek (227,910 points)
Thanks for the advice. The protocol for the remote start is iDATA...

is that right?
If that is the case you need to enable option F2 under data link protocols inside the evo-all for it to communicate with your remote starter properly.