Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

23/04/2019

 Ford julio pelayo (1650Pts.)

0

Is safety override switch mandatory if truck has factory hood pin switch?

Hi sorry for asking again, my question was is safety override switch mandatory if truck has factory hood pin switch? If it is can i get ground for it from the black wire off of the data plug wire? Also why doesn't the evo all say what hardware version it is on it and doesn't have a barcode? Installing on a 2017 ford f150 key start with keyless entry using thar fort3
Login to reply View 1 answer(s)

21/12/2017

 Ford soundman11 (130Pts.)

0

2017 ford f150 w/o factory hood switch

will your module work if there is no factory hood switch ?
Login to reply View 1 answer(s)

26/12/2016

 Ford randall mounts (220Pts.)

0

where is the wire for the start/stop switch on a 2011 ford escape?

On the 20 pin connector A13 it says to connect to the start/stop external control. What wire and where is it located on my 2011 Ford escape. Also all questions about the hood pin and valet switch say to hook them up to prevent starting when the hood is open. I understand the saftey but does it have to be hooked up for the remote start to function?
Login to reply View 1 answer(s)

19/11/2013

 Ford Shaun Dampier (90Pts.)

-2

Evo All problems with 2014 Ford Escape - missing outputs

I have installed a python 1406 with an EVO ALL without the ford harness in a 2014 escape. I am using wire to wire connections and running firmware 4.18. The programming goes as expected as far as the leds on the fortin are concerned. Step by step, after programming the blue led portion, I am able to remote start the car and learn the tach signal. After programming the bypass, I am able to remote start without a key but the remote start shuts down due to no tach signal. At any given point, the car will unlock but not lock. I have verified that the negative lock signal is making to the fortin unit. I also do not have a hood pin signal coming from the fortin. I did not have a door pin signal either so i was forced to run a wire directly to the dome light, which I would prefer not to have. I have programmed the bypass with and without the dcryptor method with the same results. I have verified connections so I am thinking it is something in the evo-all unit itself. Please help.
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue