Installed a EVO-NIST1 on a 2012 Nissan Altima along with a Fortin RF642W RF kit. Everything works great! However, I'd like to use the RF remote to open the trunk ([-] & lock) as well as turn the rear defrost on ([-] & unlock) using the accesorries slot on the EVO.
According to wirecolor.com the trunk release neg is Pin 147 on the grey BCM connector. Similarly, the rear defrost neg is Pin 19 on the green BCM connector. However, the install guide provided for the NIST1 doesn't show which wires are the auxillary outputs. Other EVO I've installed AUX 1 was the orange wire and AUX2 was the orange/black wire. Are these wires still the AUX outputs for the NIST1 or have they been disabled?
If they are enabled will I need to place anytype of resistor between the AUX output of the EVO or can I simply tap into the existing wire?
Unit: EVO-ALL
Hardware: 6
Firmware: 72.24
Wired as stand alone
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
