Just received a EVO-FOR.T1 for a 2010 Ford Fusion (automatic, key start). Have installed remotes before. Saw a You-tube video that showed installation of the four plugs on the ignition module and only 2 additional ones for Can-High and Can-Low on teh ODB-II socket. The instructions via the Fortin site (Addendum-Suggested wiring harness configuration - Guide 32161 Ver 20150428 was difficult to follow. I then registered and downloaded the Wire Color instructions (Addendum-Suggested wiring harness configuration - Guide 32221 Ver 20150428) which showed 5 additional wired connections (including a hood contact pin that wasn't part of the kit) and a need to cut a loop for automatic transmission (which wasn't on my Fortin module. It seems the module in the instructions is a EVO-ONE whereas I was supplied with a EVO-ALL.
So far, I followed the You-Tube showing the four connectors with the ignition module, and the Can-High and Can-Low. Although the You-Tube showed a successful programming cycle, mine did not turn on the ignition at the final step.
Do I need additional wiring? Do you have any clearer installation material for the unit I purchased? If not, how do I learn what I need to complete this installation.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
