Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

User

Marc Voyer

Joined on the:

Oct. 31, 2008

Score

920

Comment(s)

22

Voted question(s)

0

Voted answer(s)

4

Votes up

0

Votes down

4

Votes up received

13

Votes down received

0

Recent Activity

Question(s) asked

12

Answered question(s)

2

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question
RECENT ACTIVITY QUESTION(S) ASKED ANSWERED QUESTION(S) COMMENTED QUESTION(S)

08/05/2015

 Ford Marc Voyer (920Pts.)

0

2013 Fusion Evo All stand Alone start on single lock only and won t start on three lock. Randomly.

I ve installed the Evo All that was previously ready for a 2014 Dodge . I did reprogram to 2013 Fusion with regular key. Is there an update for Stand Alone Ford Fusion program ? Should I have use a basiv Evo All instead of one ready for a Dodge ?
Login to reply View 1 answer(s)

22/12/2014

 Dodge Jesse Hir (680Pts.)

0

Evo-Chr T1 can i use it for 14' Caravan??

I have a old Evo-Chr T1 still in stock and ran out of harness 4's. Is it possible to use this set up in a 14' Caravan? If so, which firmware should it be updated too?
Login to reply View 1 answer(s)

21/11/2014

 Dodge Marc Voyer (920Pts.)

1

2013 Dart manual transmission ready mode do not execute properly

Auto Start remote starter , the costumer complains it will not enter ready mode unless all passenger has left the car and then they make the sequence for ready mode. In other word, if they have car running , with key in their hand and all together or almost everyone exit the car, then when all doors are closed ( I hope ) they click " lock " the car shuts down but will not remote start. What I undurstand it seems if more than one door is being operated during the ready mode execution , it seems to react like if someone had open the door after the completion of ready mode. Is this nature of the beast ? Or could bypass send multiple door status pulse to the remote box and jinx the sequence. ? I know this is a tricky question and to make things worst I haven't install this.
Login to reply View 2 answer(s)

10/11/2014

 Jeep Marc Voyer (920Pts.)

1

Clutch bypass 2014 Jeep wrangler.

Hi I am using the neg when running to bypass my clutch wire but it s not going to zero volt like the OEM switch does. Can I use On 6 pin red connector from Evo All , the white/ blue and white / red wire One to ground and other to cluch switch as my clutch bypass ? Thanks , Marc.
Login to reply View 1 answer(s)

21/10/2014

 Toyota Marc Voyer (920Pts.)

1

Stand Alone Evo All 4Runner 2013

I just made an install of a stand Alone Evo All on a 2013 4Runner Push to start Programming went as told in instruction Hardware 6 79.11 Monitor oem remote selected stand alone evo all selected. Car flashes the 4 ways each time I press lock, red led come on on evo parking lights come on at some point after i clic 3 times then go out then come back on ( I suppose the off time is when car should be cranking ) then parking light goes out and red led goes out. I saw blue led react each time I press lock on oem smart key. At my evo module, If i turn on car ignition i do have power to yellow wire and steering lock volt does go to ground. BUT when i remote start 3 x lock I don t see my steering lock signal go down (dvom) I don t see ignition power coming on (dvom)
Login to reply View 1 answer(s)

19/04/2014

 Pontiac Marc Voyer (920Pts.)

1

Is there a way to bypass 1998 Grand-Am with a single wire to Car Data Connector pin # 2 or Pin #9

We are building a Snow plane with a 3.1 GM from a 98 Pontiac grand am. I know the VATS send info to PCM via data wire pin # 9 on Car Data Connector. can I try a evo all to achieve same thing ? We don t want to install cluster and key cylinder in machine thanks.
Login to reply View 1 answer(s)

21/01/2014

 Ford Marc Voyer (920Pts.)

1

2012 Expedition SA keys EvoRide wont program

After fighting like an idiot, I finally came to the FAQ where it says, even with SA keys it might be a 40 Bit. YESSSSSSSS column looks like a 2009 F250 it all makes sens. So I program Evo Ride like a 40 Bit. All sequence goes good, led flashes, hit brakes, remote shut down. Try to star truck it starts. yey . Attach byass under dash ect. Try again , No Start. Being a 40 Bit I decide to try a Key Overide All. did same truck started righ away on programing sequence. attach modul under dash ( very softly not to pull any wires away. 0 truck don start again Theft light is flashing like it should with wrong transponder.
Login to reply View 1 answer(s)

15/01/2014

 Pontiac Willy Friesen (200Pts.)

1

2004 montana doesn't start

prostart installed, evo-all installed with 4.06 firmware. cammand start activates all lights but does not attemp to start the engine, no crank. wheres the problem?
Login to reply View 2 answer(s)

13/01/2014

 Ford Marc Voyer (920Pts.)

1

Do I need to connect all the can wiring just to start car with Evo All Taurus 2010

I have a stubborn Ford Taurus that don t want to program evoride. Tech told me to use Evo All Do I need to connect yellow ignition to immo power absolutely ? Can I just connect the the related wires to the 20 pin connector only in order to start car ? since I had everything done before with evo ride
Login to reply View 1 answer(s)

13/01/2014

 Ford Marc Voyer (920Pts.)

1

Evo Ride don t program Taurus 2010

Can t find version 2.04 on flashlink 3.31
Login to reply View 1 answer(s)

10/12/2013

 Chevrolet Marc Voyer (920Pts.)

1

No start 2009 Chevy colorado

As 2471 TW FM + Evo all connection 8 guide 12281 Le evo a programmer ok je crois car meme les door lock marche ( unlock only ) meme si pas equiper. En remote start il y a une sequence de led sur le evo all ensuite le Autostart crois que ca tourne car le timer fonctionne. Le evo as les 3 led fonctionne, bleu clignote, rouge et jaune semble solid.
Login to reply View 1 answer(s)

04/12/2013

 Subaru Marc Voyer (920Pts.)

3

Can we program a bypass without a key for 2008 Subaru Impreza

A customer told me i-data link has a " decryptor ' type system to program all Subaru. He has a 2008 Impreza. I didn t look into that myself. I don t deal with other than Fortin. Maybe your website is not up to date yet and you do decrypt Subaru keys now.
Login to reply View 1 answer(s)

04/12/2013

 Subaru Marc Voyer (920Pts.)

2

Can we bypass a 2008 Subaru Impreza without a factory key now ?

I got a costumer who wants a remote starter for 2008 Impreza. He went online and told meI-datalink has a decryptor for Subaru. Did you develope this function for Subaru so far and your website is not up to date. He told that would cover his 2008 Impreza also.
Login to reply View 1 answer(s)

20/11/2013

 Pontiac Marc Voyer (920Pts.)

0

2008 Pontiac G5 evo all security light stay on after remote start.

Do I need a soecific update on evo all ?
Login to reply View 1 answer(s)

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue