I have installed a python 1406 with an EVO ALL without the ford harness in a 2014 escape. I am using wire to wire connections and running firmware 4.18. The programming goes as expected as far as the leds on the fortin are concerned. Step by step, after programming the blue led portion, I am able to remote start the car and learn the tach signal. After programming the bypass, I am able to remote start without a key but the remote start shuts down due to no tach signal. At any given point, the car will unlock but not lock. I have verified that the negative lock signal is making to the fortin unit. I also do not have a hood pin signal coming from the fortin. I did not have a door pin signal either so i was forced to run a wire directly to the dome light, which I would prefer not to have. I have programmed the bypass with and without the dcryptor method with the same results. I have verified connections so I am thinking it is something in the evo-all unit itself.
Please help.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
