I am unsure that my remote starter (a Viper 5706V) is communicating properly with the EVO-All.
I updated the flash to enable D2D, but it makes me suspicious that this category was hidden from me in main screen of the flash manager software.
Is there any way of telling if the D2D communcation is set up properly? Is the D2D comm just standard UART? If so is it human readable ascii or just a byte stream?
I am attempting to install this setup into a 2011 Nissan Xterra
When I attempt to remote start I, the ignition turns on but there is no starter turn over despite power at the starter pin. The alert on the dash also indicates that the key is missing. Alternativly if the key is in the ignition the car will remote start.
When looking at the EVO-All
The Yellow ignition light does come on
but neither the Blue or Red LEDs come on, this is despite having the GWR wire hooked to the 5706V
I have looked at the installation of the EVO-All with other DEI products like SmartStart but have not found anything about the 5706V, 5704, or 5702. Do you know if DEI uses the same D2D pinout across their products? When I opend up the 5706, I am pretty sure GND and Power traces are correct but the blue and white are not so obvious.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
