Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

Everything is plugged in but LED will not flash rapidly in step 5

Toyota 2016 Prius TOYT6 T harness I am using the guide : Regular Installation without Take Over with T-harness Hello, I spliced into the 3 wires that were needed. 2 at the OBD2 connector (ground(4) and +12V(16) and 1 wire at the hybrid ECU connector (+) starter(A16). I took out the 30 pin main body ECU and plugged in the 30 pin connector labelled B from the T harness into it. I then plugged in the 30 pin main body ECU into the T harness female 30 pin side. Am I missing anything? I plug in the power wire into the Fortin module while holding the button and I waited until it turned solid blue. I then connected the rest of the connectors into the Fortin module. I pressed the power button on the vehicle twice without pressing on the brake. The blue LED stays solid and does not flash. When I turn on the car fully, the LED blue light still stays on. If I turn off the car, the blue LED light is still on

0

Evo one wont finish programing

I have a 2011 Tacoma gkey. I've tried evo all and evo one. When programming I get to the point where the LEDs flash rapidly red and blue. Turn the key on and I dont get a blue led solid or flashing. I notice on the diagram that the obd2 hook up is marked as imo wire.my diagram says its sils. My imo is behind the glove box. Is this what can cause my issue

0

My evo all blue light won't flashed rapidly when press the push to start twice to program it

I want to program my evo all on my toyota camry 2011 hybrid but the blue light is not flashing rapidly when i push the start button twice

0

2014 camry se, with axone , toy2 t-harness, revo1. remote. remote not working.

evo goes thru programming fine, then using valet switch to program 2 remotes, key on , holding valet , i get rapid flashes, push 5 times ,watching red light flash each push, press brake , press button on revo1 and doors lock and unlock? , turn off key, 4 flashes at yellow cut wires, then i press remote and all i get is one blue flash on evo and 2 blue flashes on evo when second remote is pressed. tried key on , pressed remotes and the doors lock and unlock , cant figure i out. bad revo 1? axone? Also the parking lights do not flash when programming the remotes. and no red flash at the loop after the brake pedal is depressed. The crimestopper has to black plugs one goes into the blue connector and i put the other into the data link, if i leave the one out of the data link connector the it doesnt work at all.

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer