Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Utilisateur

Brandon Cleary

À rejoins en date due:

Dec. 27, 2017

Points

1250

Commentaire(s)

10

Questions votée(s)

0

Réponses votée(s)

3

Votes positifs

0

Votes contre

3

Votes reçus

4

Votes négatifs reçus

0

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

0

2006 Infiniti FX35 EVO-ONE intelligent key question

I know that there are reasons why on some installs an RF kit is required. I'm wondering what the reasoning is for an 06 FX35? I did an install with one and the vehicle starts and stops via the factory remote. My plan was to use an RF kit and Drone Mobile but it seems the RF kit isn't needed.

0

If module is disconnected for any reason, do keys have to be reprogrammed

0

2009 Scion TC no keysense

I'm trying to install a EVO-ONE and RF kit into a Scion tC but there's no keysense so I cannot program the module. Is there something else I can do?

0

EVO-All flash locked

I can't flash or change settings in the module. I'm trying to update the firmware so the engine doesn't shut off when the customer opens the driver door. Can you please reset the module for me?

0

Can I trim the extra wires from my THAR once installation is complete?

I have a 2016 Mazda 3 doing a stand-alone install with a T-Harness. Following the guide: http://cdn02.fortin.ca/download/62681/evo-all_ig_tsa_bi_maz1-3_pts_2014-2017_door_v2_e_62681.pdf. Once completed, I will have only connected A8 and A20 directly from the "A" connector. Can I cut the other wires from the A connector for a "cleaner" installation? Obviously I would leave A1, A10, A19 because those are fed from the t-harness connections. Also, if I have no plans of adding an RF kit, can I cut/remove the white & blue wires on the "B" connector as well as the "extra" red and black wires leading to the RF kit? Like I said, just trying to make the cleanest install I can.

0

Ram Promaster City

Flashers run continuously when vehicles remote started. Has OEM alarm, wired as such.

0

2018 Elantra PTS Remote trunk pop not working.

Everything else works; parking lights, remote start, key take over, door locks. The factory remote won't pop trunk when in remote start mode.

0

Why does the 2014 Audi S4 not require key but 2015 does?

I am interested in purchasing an Evo-One for the 2015 Audi S4 Keyport but I am wondering why the install is more difficult than the 2014. Are you planning to introduce a new product that doesn't require the key for the 2015 or will this always require the key?

0

2018 Ford ECOSPORT "Yellow Service Wrench on Dash Illuminated after takeover"

Evo-all installed on a 2018 FORD Ecosport. Vehicle starts and runs. However after you press the push to start button during takeover, all the dash indicators illuminate like normal, all then go off except the Yellow Wrench. No codes are generated, the vehicle runs fine, but until you shut down and restart the vehicle, the indicator will stay illuminated. Ive worked with your tech support on the phone and they have no answer to this issue.

0

Replacement valet switch available?

During installation of an EVO-ONE unit, the valet switch fell apart and is not repairable. Is a replacement valet switch available?

0

Remote start doesn't work FX 50s 2012

good evening. Need big help. I did instal EVO-ALL with T-harnes, did flash with modile to 72.34 , programm with the fob. And when time come to try - no reaction. I see module flash 3 times blue when activating remote start with OEM fob, then turning red (i think it's trying to start) for few seconds, then it' turning off and turning on again for few sec and then off. Aftger this blue light blinks 3 or 4 times.White -black wire connected as per diagramm (for my car to light blue on the back of push-to-start botton). Red connector i tried both R1 & R2. On the module A1-A11 ON, C1 & D1 ON, D1.6 & D1.10 ON, D2 ON. Do not Have any idea what next. One more thing, on White-Black wire i measured 10V when it wasn't connected, is it shiuld be like this? End when i trying to start nothing heppening in this wire, 10V always. Thank you in advance.

0

Immobilizer bypass won't work for Eclipse Cross

Hi, after the dcryptor programming completed, the immobilizer bypass still wont work , it still require the OEM key present to start up the car. Remote start won't work as well. not sure link to the immobilizer bypass.

0

EVO-ONE w/ DRONE MOBILE 0.50 REMOTE NO UNIT OPTIONS / WONT START

EVO-ONE / DRONE MOBILE - VW TIGUAN 2017 PTS AUTOMATIC I had everything installed and working with the most current firmware(Bypass 75.38, Remote 1.24) , 3x start etc. But when I flash to 0.50 for the remote side for Drone Mobile it takes fine but I CAN NOT find the offline options anywhere no matter how i connect up the unit, the "unit options" is just missing from the CONFIGURATION menu no matter what I do (CTRL O), hence the car will not start as I can set the 3x remote to start option? It shows "unit connected, Firmware: 0.50, Connection mode: Remote-Starter but no offline options? HELP!

3

EVO-ONE and Drone DR-5400

I just wanted to come and say that the Drone DR-5400 does work with the EVO-ONE when following the DR-3x00 instructions. I've successfully installed one and got the remote start, lock/unlock/truck/vehicle status working.

0

Decryptor Limit reached

Doing some troubleshooting I have reached the decryptor limit. I unplugged my module to change some settings and when I plugged it back in I got nothing from the unit. Not even a blue light when locking/unlocking. So I did a factory reset reset. Got to the point where I have to run the decryptor a second time (alternating yellow/red lights) and I'm being told I've reached the limit. If you could reset this that would be great. Thanks. 2011 Golf EVO-ONE with TB-VW

1

2011 Golf EVO-ONE w/Drone DR-5400 Lock/Unlock issue

Hello! Finally got my EVO-ONE and Drone working on my 2011 Golf manual TDI. I can get the Drone to start and stop the vehicle. I even got it to open the hatch. However it wont lock or unlock the doors. If I hit unlock it seems to engage the ingition for a split second(gauge cluster and radio lights up) then turns off, and then the yellow light comes on. If I hit unlock again it does the same thing and then the yellow light will turn off.(The blue light does not flash at all.) If I hit lock the blue light will flash extremly quickly once but nothing else happens. I don't want to have to keep flashing the unit and hit the flash limit because I can't change options when loaded on 0.50 RS firmware.

0

2011 VW Golf TDI manual issues w/ EVO-ONE

Hello, I'm installing an EVO-ONE and Drone 5400 module on my personal car. I've followed guide 61571 and even got the decrypter fully programmed. However I can not get it to remote start. When I press lock 3x the blue light doesn't light up like it has on every customers vehicle I've installed. I've checked and made sureall wiring was correct. Not sure what I'm missing here. I haven't gotten to install and configure the Drone yet since I can't get the remote start to work. Thank you. UPDATE: Reporgrammed the module and now it works. The only problem that I have is the EVO-ONE will send the unlock pulse 4 times when enabling idle mode/ready mode. How can I get this to stop and leave the unlocking/locking to the vehicle? Also I would like to use the alarm features of the EVO-ONE. Is there any special connections I need to make?

0

2018 F150 EVO-FORT2 Programming issues

2018 F-150 STD-key w/ keyless. After inserting the second key, then removing it, the ignition turns on, then nothing else happens. The lights are solid red and yello. I've tried multiple firmwares but they all do the same. I've also verified my wiring. I'm not sure if this matters but the module is an OMEVOALL. Omega branded.

0

2019 Kia Sorento Standard Key options

Is there any current options that are available to be used or is there an ETA for 2019 support?

0

EVO-ALL key programming reset

Installed EVO-ALL in a vehicle not realizing it didn't wouldn't monitor the factory remotes(learned my lesson of over working myself.) Anyways I got all the way up to programming and was sucessful. I've decided to put this module on my personal vehicle (2011 VW Golf) with the TB-VW. Can the key data be "deleted" so I can reprogram it to my vehicle?

0

2010 Mazda 3 EVO-KEY D2D support

Hello! I have a customer that I plan on using using an EVO-KEY and Viper 4115V1B. Will the D2D protocol work or will I need to wire2wire?

0

which part i have to buy

how i know which part i have to buy?? ihave kia optima 2015 remot standred key

0

2016 Fiesta Base Manual Trans

Is there a way to set one up on a manual trans?

0

2012 PTS Taurus installation issues

I'm installing an EVO-ALL into a '12 Taurus PTS. I've followed the the guide for stand-alone installation but I'm having a few issues. 1) After I plug in the 4 pin power connector(jumped from a constant 12v and ground), plug the rest of the connectors in, I'm unable to press the buttoin 3x to get into programming mode. The yellow light stays solid. If I just plug in the power, then press the buttion 3x then I can get into the correct mode and start programming. 2) I can fully program the module but when I goto Decrypter I get Empty Key data. All of the LEDs blink properly. I even get the slow blue LED flash atr the end of programming. If I plug the power back into the module the blue light will continue to blink slowly. 3) Update: I was sucessfully able to get the decrypter to work but now when I plug the module in the yellow light will stay on. If I try to remote start I get the red light will come on then turn off but no start. It seems the ignition wire is wrong in the manaul. At that connection there isn't a gray/brown wire but the violet/white wire is in it's correct location.

0

'11 Golf TDI 6spd parts needed

Looking to add remote start to my TDI. I'm looking to see if there's anything special for the TDI 6spd.

No results

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

Support Technique

Recherchez parmi nos produits les plus populaires et les sujets d'installation disponibles dans notre section Questions et réponses.

En savoir plus
Téléchargez notre application de guides de dépannage étape par étape disponible pour iOS et Android ou parcourez notre version de bureau.

En savoir plus
Accédez à la plus grande base de données de schémas de câblage et de photos en ligne de l'industrie. Un jeton gratuit est fourni dans chaque boîte EVO-SERIES.

En savoir plus
Vous n'avez pas trouvé l'information que vous cherchiez ? Posez-nous une question en remplissant le formulaire de demande de support technique. Un spécialiste produit vous répondra sous peu.

En savoir plus
Des solutions de contrôle à distance et de connectivité à la fine pointe de la technologie au soutien technique haut de gamme, découvrez pourquoi vous devriez choisir les produits Fortin.

En savoir plus

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer