Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

04/01/2020

 Jeep Mark Perestrelo (160Pts.)

0

2005 Jeep Grand Cherokee Air Bag Warning Light

I just installed the EVO All with the T-Harness in my 2005 Jeep Grand Cherokee following the F installation guide. If I 3X lock to remote start the Air Bag Warning light comes on and stays on until the vehicle is shut off and started with the key fob. I do not have this light coming on if I start the Jeep with the key fob normally.
Login to reply View 1 answer(s)

05/11/2016

 Lexus G M (13110Pts.)

0

airbag lamp

I installed key override all on lexus GX460 and on the second day airbag lamp lighted up. Why? Remote start system- Avital 4103. (door open before start, lock with wire start(-), and again lock after shut down-12min).
Login to reply View 1 answer(s)

16/12/2015

 Audi Rob Brown (140Pts.)

1

Audi A3 Yellow Ignition + Airbag

Hello, following the instructions through the Fortin & wire-colour sites, the yellow ignition wire connection is under the steering column. The picture on wire-colour shows the airbag controller dissasembled. The airbag module on the A3 is sealed with a caution sticker suggesting that the airbag must be disabled before disasembling - I can't find instructions on your site or wire-colour for disabling the airbag, and neither site specify that work is required around the airbag controller. I'm aware that airbag capacitors carry a charge even after the battery is disconnected, and I attempted to disconnect the ingition harnes and gain access to the yellow wire without messing with the airbag controller, but since the ignition wires pass through behind it, it seems impossible to access the wire and make that connection without dissasembling the airbag controller - I abandoned installation at this point as I could not find a safe way to proceed. Even without disassembling the airbag controller, the air bag warning is now lit in the dash and will need to be cleared - it must have sensed that I was poking around. Since airbags are both expensive and critical for safety, can you provide more detail on steps to access the yellow ignition wire, and how to disable the airbag without risking firing it, or accidentaly breaking it/permanently disabling it? Thanks, Rob
Login to reply View 2 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue