Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

Questions & Answers

Browse among the most frequent and popular questions and find accurate answers.

recent questions tagged: ...

Clear All
Collapse All
Expand All
Clear All
Collapse All
Expand All
picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask us a question
RÉCENT HOT! MOST VOTES MOST ANSWERS MOST VIEWS

23/01/2022

 Nissan shahid islam (130Pts.)

0

How to connect D4 D6 , 2006 Nissan Altima

I'm using evo-one with niss2 harness for my 2006 Nissan Altima I am confused about the connection D4 and D6 showing guide #78211. I also don't know where to connect the pin 30 from the relay for parking lights . A picture would be great, or can I leave the parking light unconnected? The last question, do I have to have a RF module to remote start? Because when I put my key at on position, the blue lights went off.
Login to reply View 1 answer(s)

02/05/2021

 Nissan Eric Laing (390Pts.)

0

2016 Juke parking light wire resets car features

I have 2 2016 Nissan Jukes, yes, his and hers. My starter works fine and turns on the parking lights (brown wire to purple wire of green pin1 at BCM connector), when I put the brown to purple in my wifes car, the lights don't turn on and it resets the radio/time to factory, every time. Again, identical 2016 Jukes. I am NOT pulling the starter out of her car as where I have it tucked in takes a long time to get at. Verified 12v at purple wire with manually turning on the parking lights but when remote started the Fortin brown wire has nothing. Ideas?
Login to reply View 3 answer(s)

16/01/2021

 Nissan Ward Hayes (210Pts.)

0

No parking lights or horn alarm chirp. Please Help!

Installed the Evo One for my lady, 2017 nissan sentra, standard key. I did the key bypass programing procedure as it said in the directions. I belive the oem remote should work with the 3x lock. When I hit the lock button the blue light flashes as it should. But no remote start with 3x lock button, and no parking lights or horn chirp to signal alarm has been set. Any advice? Thanks in advance.
Login to reply View 1 answer(s)

04/12/2020

 Nissan fred abbott2 (240Pts.)

0

parking light not work

have a 2019 nissan sentra push start, every works but when running, parking light will not come on.  try to hook up brown wire on t harness to green plug wire is not purple as show in diagram it,s white / purple and has power when you turn headlight on it a evo one with nis1 t-harrness can anyone help please

Login to reply View 1 answer(s)

20/12/2019

 Nissan Rpatel1053 (190Pts.)

0

Parking light when remote started

I have checked the brown wire from the T harness. The wire has good connection. That brown wire has a small relay (possible). Is it possible that the relay is no good? How do I test that relay
Login to reply View 1 answer(s)

28/10/2019

 Nissan Justin Stroud (270Pts.)

0

2018 Nissan Frontier Guide # 72031 - parking lights and horn, and lock/unlock

Successfully installed an Evo One with THAR-ONE-NIS2 and remote start is working. In the guide, it points to the hill assist button to tap into the parking lights, I do not have that button, and I could not find the plug near there to tap into it. Is there another option? I also have no horn when arming / disarming / starting. The guide doesn't mention one, is it possible to have this? Locking with the remote works, but unlocking can usually takes hitting the button twice. Is this normal, or do I need to triple check my connections? I ran the purple and purple-white wires to the lock/unlock wires in the driver side kick panel.
Login to reply View 1 answer(s)

17/02/2019

 Nissan peter swietek (210Pts.)

0

How to connect parking lights in a 2016 nissan pathfinder

on my 2016 nissan pathfinder Im not sure wich wire from the evo controls the parking lights it doesnt say it in any of the diagrams. also i dont know if its a positive signal or negative. the product im using is a evo nist4
Login to reply View 1 answer(s)

06/01/2019

 Nissan Jason Guffey (160Pts.)

0

16 Nissan Frontier no parking lights or horn

Tried the third time and everything seems to program and work except no horn or parking lights flash when starting or unlocking/locking? The remotes work and lock/unlock and remote start and shut down like normal. This is on a 2016 Nissan Frontier. Any ideas?
Login to reply View 1 answer(s)

17/10/2018

 Nissan eric powe2 (130Pts.)

0

Parking Lights No Start

When I hit lock 3Xs the cars parking lights flash but the car will not start on 2011 Nissan Maxima I have a smartstart hooked to the unit that i have to get activated today and need this unit to be working properly also for the viper smartstart which tab should i cut on under the rf kit for it to work
Login to reply View 1 answer(s)

19/01/2018

 Nissan Daniel Waslenko (2650Pts.)

0

2011 Nissan Rogue Parking lights don't turn on

I connected it to the red wire with silver dots on the harness going to the back of the vehicle as listed in wirecolor.. There were a number of red with silver dots, but only one that had 12v + when the parking lights were turned on. I even manually fed 12v+ to the wire and they would not turn on. Is there any other way to power up the parking lights? is there any possible connection at the parking light switch?
Login to reply View 1 answer(s)

26/11/2017

 Nissan Mark Whitman (240Pts.)

1

EVO-ONE No Horn or Parking lights with alarm or remote start

2008 Titan EVO-ONE with T-Harness install. RF642W remote module. Parking lights and Horn fail to function during Locking and remote start. All functions work except Lights and Horn.
Login to reply View 1 answer(s)

27/12/2015

 Nissan James G. (340Pts.)

0

Ground while running wire has a constant 12v reading

After installing a Prestige APS787E alarm w/ my Evo-All bypass module on my 2012 Nissan Rogue (Non-Push2Start), my lock, unlock & trunk buttone on the aftermarket keyfob work but the remote start doesn't work. I updated my Evo-All to the latest firmware & hardware available & flashed it to D2D protocol.

I also programmed the Prestige alarm using the install guide to get the Tach signal via D2D mode. But when I attempt to follow the "Tach rate progarmming" section of the manual, it is clear the alarm might not be getting a tach signal.

Is it possible to hardwire the tach signal to my alarm while using data mode w/ the Evo-All?

Secondly, I test the "ground while running" wire connection btw the Evo-all & Prestige alarm with a multimeter and I get a constant 12V even when trying to remote start. Is this normal? I thought it would/should give me a 0V or ground signal when I attempy to remote start the car.

Lastly, also just noticed that my Prestige key fob arms the aftermarket alarm but locking my doors w/ the OEM Nissan keyfob doesn't. Thus when I arm the car w/ the Prestige keyfob & unlock & open the doors w/ my Nissan key, the siren goes off. Is this normal? 

Thanks in advance
Login to reply View 1 answer(s)

10/10/2015

 Nissan Rick Felter (320Pts.)

0

2015 Nissan Frontier EVO-ONE/THAR-NIS2 and Parking Lights

The installation guides for the Frontier do not mention hooking up parking lights. Is this controlled by CAN-Bus or is a connection required somewhere?
Login to reply View 1 answer(s)

29/01/2015

 Nissan Jason Steward (200Pts.)

0

EVO-One + Thar-Nis2 standalone, parking light and tumbler connections

I used guide #17763 Rev. 20150121 on a 2010 Nissan Pathfinder with Intelli-Key. I did not make any connections for the parking lights as it is not shown in the guide. The parking lights are not coming on when I remote start with 3x lock. The install guide for the unit without the harness (#17233) shows connections and a relay for the parking lights. Do I have to install the relay and make the connections or are the lights controlled through CAN and just aren't working? Also, in tesiting I have noticed that if someone is in the vehicle when it is remote started they can turn the tumbler to ON and drive away without unlocking any doors or having the Intelli-Key in or near the vehicle. I made the following connections to the tumbler: white/red to red/blue - 12v white/blue with diode to red/blue - key sense another wire with a didoe spliced to white/blue before it's diode and going to red/white - tumbler sense I am not having any problems with it locking up but was wondering if it is normal that the tumbler can be turned without the key being in the vehicle. Could it be a backward or faulty diode or have I made a mistake in the wiring? One more note: the darkblue wire from the EVO that is to be connected to the doorpin wire for the autolight shutdown was causing the engine to shut down when the door was opened. I noticed that after a remote start the door open indicator was on then I cut the dark blue wire and that solved the problem. Function 32-2 was enabled as per the install guide. Not sure if this could be a wiring issue or an issue with the install guide or firmware. Thanks for your help.
Login to reply View 1 answer(s)

18/01/2015

 Nissan Darius Sherman (260Pts.)

0

Parking Lights

When remote starting my car, my parking lights never come on. 1. Are they supposed to be on? 2. If yes, how should I go about fixing it? 3. Will the lights remain on when I shift into drive? This is for a 2011 Nissan Altima Push-To-Start. With the Evo-Combo for Nissan.
Login to reply View 1 answer(s)

05/06/2014

 Nissan Steve Lau (130Pts.)

0

where to connect the parking light wire

Hello, I bought the EVO-ALL with THAR-NIS1 for my Nissan Juke 2012 ( PTS ) using document Rev20140327 ( Guide 12681 ). At the bottom right corner of page 4, there is the Parking Light wire connection. Diagram shows should connect to the pin-8 of the 10-pin white connector of the Fuse Box ( driver lick panel ). I find the fuse box but never find such connector. Is there any alternate way to connect this Parking Light wire ? Thanks. Steve
Login to reply View 1 answer(s)

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue