Français
My account Register
Français
EVO-START Wirecolor

Your Cart

Your shopping cart is empty.

Your shopping cart is empty.

Continue Shopping

ESTIMATED TOTAL:

Checkout

QUICK VEHICLE FINDER

VEHICLE FINDER

User

8itgreat

Joined on the:

Oct. 17, 2020

Score

630

Comment(s)

16

Voted question(s)

0

Voted answer(s)

2

Votes up

0

Votes down

2

Votes up received

2

Votes down received

0

Recent Activity

Question(s) asked

6

Answered question(s)

4

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question
RECENT ACTIVITY QUESTION(S) ASKED ANSWERED QUESTION(S) COMMENTED QUESTION(S)

19/11/2020

 Chrysler THOMAS WRIGHT (130Pts.)

0

i bought from fortin but my unit wasnt flashed upon delivery

i bought my evo all through amazon beliveing it was pre flashed for my 06 pt cruiser but it wasnt is there anything i can do beside buying the flash for this one car im doing
Login to reply View 2 answer(s)

07/11/2020

 Chrysler jose gutierrez2 (130Pts.)

0

Flash link not detecting my module when connected to my computer

Flash linker connected to computer and module but the flash link manager says module not connected and module is connected and lights will be blinking red yellow and blue if I put it as a special unit and if I don't put on special unit on configuration it only gives me one solid red light and still says unit disconnected
Login to reply View 1 answer(s)

30/10/2020

 Chrysler 8itgreat (630Pts.)

0

2005 Chrysler 300c Evo All Standalone install Chrt5 T Harness Part 3 (Solved)

I have fully installed wiring using Military Splice method with a stripping tool. Each wire has 3m electrical tape and a small zip tie. So clean the military would be proud lol.

 

I have triple checked the wiring and everything is right. I think we're at a point that you need to look at my Service Tag # 001A07135564. 

This car will not remote start, shouldn't be this difficult. Perhaps a bad T-Harness???  

I see you used my ignition harness picture on WireColor.com lmao, maybe you should have waited. Also  see you revised the install guide as well using my info. If the car won't start, how is this helping?

I went over the colour of each wire several times to be sure before I made this post. HELP! 

Login to reply View 2 answer(s)

19/10/2020

 Chrysler 8itgreat (630Pts.)

0

Install help. Evo All Stand Alone install with T-Harness CHR5 2005 Chrysler 300c

Stand Alone Evo All with T-Harness CHR5 2005 Chrysler 300c   Have a few questions before install on a 2005 Chrysler 300c using the EVO ALL with T-Harness CHR5. I'll have the unit at the end of the week and just want to go through a quick walkthrough on how I think the install should go.   (No hood pin or saftey valet switch so not talking about those connections).   Will be using Parking Lights.   Unit arrives. Flash the update puck to most recent software and firmware. Then update Evo All to your cars model year trim and set settings, save, exit , unplug . I will do a quick check using Wirecolor website to make sure my wire colors are correct   Wire Harness yellow wire and yellow (A1) on 20 pin connector are connected and isolate Purple wire on harness.     A14 (MUX) Parking Lights wire cute and solder a 2.4k ohm resistor 1/4 watt wrap some electrical tape and connect it with T-Tap on pin wire (from headlight switch) position 1 white/brown wire.    A18 (Mux) from 20 pin goes to position 2 (Purple/Brown) on Ignition Switch with T-Tap   5 Pin white connector just seems to plug in without isolating any wires.   Now the RED connector uses 3 of 6 of it's wires.  Also says "IF (+) STARTER WIRE IS PRESENT" for D6. This is my stop gap. Are these D3,D6,D5 T-Tap connections or kept on the harness and wires not used isolated. Also if my starter wire is not present do i isolate D6 as well?   If I get past this I see the programming side is straight forward. Once done and keys are programed unplug unit and use the update puck and run Dcryptor , check settings again, save and exit. Put it back in the car , test, button her up.
Login to reply View 2 answer(s)

No results

picto contact

Looking of our top participants?

See users
picto contact

Couldn’t find what you were looking for?

Ask a question

TECHNICAL SUPPORT

Search through our most popular products and installation topics available in our Question & Answers section.

Learn more
Download our step-by-step troubleshooting guides app available for both iOS and Android or browse through our desktop version.

Learn more
Access the industry’s largest online wiring diagrams & photo database. A free token is provided in every EVO-SERIES box.

Learn more
You did not find the information that you were lookingfor? Ask us a question by filling out the technical support form request. A product specialist will answer you shortly.

Learn more
From state-of-the-art vehicle remote control and connectivity solutions to premium technical support, learn why you should choose Fortin products.

Learn more

This website uses cookies to ensure you get the best user experience. By continuing to browse our site, you are agreeing to our use of cookies. Learn More Continue