I have an Evo-One installed on a 2008 Mitsubishi Eclipse, Manual Transmission. The car is equipped with the factory alarm. I have function 32.5 (Ground out - Arm/Rearm) enabled as the installation guide states. It is connected to the Lt. Green driver door pin wire. However, after I put the car in “ready mode” when the car shuts off after I close the driver door and the pulse gets sent to the door pin (to arm/rearm factory alarm) it disables my “ready mode” as well. When I figured that out, I disconnected the (-GWR) wire from the door pin wire and the remote start works perfectly. Only thing is now the factory alarm doesn't arm after shut down of the remote start. Is there anything I can do? Or should I just keep that wire disconnected since everything else works fine.
Also, what wire do I use to connect an AUX output? I’d like to wire in my rear defrost to activate when I press Aux 1 on my remote.
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
