Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

18/05/2020

Honda JR (130Pts.)

0

EVO One Module Not powering up after Parking Lights, horn and Door Lock Connection

I just purchased an EVO one with a THAR-ONE-HON1 T-harness for a 2011 Honda CRV. I successfully programmed the module prior to installing it in the vehicle using the Fortin Flashlink V4. I installed the T-Harness onto the vehicle without connecting any of the horn, parking lights or door lock provisions at first, so that I can perform the key bypass procedure. I was able to set this up successfully with no issues. I even tested that the vehicle would be able to be started via the 3x lock procedure. All was perfect.

 

I then proceeded to connect the parking light connection along with the horn and door lock connections. All of the instructions were used based off of the 57711 guide. I also used the activation code for the wirecolor website prior to splicing any connections. I also verified with the colors with my service manual and all was good. After splicing into the factory connections for the horn, parking lights and the door lock, I proceeded to attempt the remote start procedure and the vehicle. The parking lights and horn worked flawlessly, the door lock however would not unlock. I had to manually open the door to unlock it. I then proceeded to turn off the vehicle, I figured maybe it was a glitch.

 

I then proceeded to attempt to remote start the vehicle again and this time the vehicle would not start. The module would not even light up, no color would show. The module seems to be dead now. I have verified all connections twice before splicing into the factory harness and then proceeded to verify another two times afterwards just to make sure that I did not accidentally wire anything incorrently. Everything is connected exactly as the instructions show. I'm not sure exactly what could've caused the module to stop working with everything being connected properly. Please help. Thank you!

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer