Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

06/10/2020

Kia Gdrover (400Pts.)

0

2010 Kia Rondo Remote Evo One will not power on

2010 Kia Rondo Standard Key start Evo One, Firmware updated to 76.58 T-Harness THAR-ONE-KHY1 Rermote RF642W, All wiring confirmed correct per Instalation Guide 60981 Rev 20171108, Module confirmed to be programed correctly with Rapidly flashing Yellow LED. All door locks operate correct, they lock and unlock with remote. WhenRemote start sequence is intiated with remote the doos lock but no blue yellow or red light will turn on.Accessories and ignition will not activate and the engine does not crank. The blue light on the antenna flashes rapidly and there is a red light visable behind the Auto trans wire loop which is cut for automatic trans mode. The park lights only flash when locking and unlocking the doors. The hood switch is confirmed to only be grounded with the hood open and not grounded when hood is closed.

0

2012 Kia Rondo Evo One - Car not remote starting, no crank

Hi, I installed a 2012 Kia Rondo Evo One T-harness. After installing everything, programming the module and remotes. After the installation, I noticed I had put the KHY2 instead of the KHY1. The car isnt remote starting, no crank. Im assuming that if I installed the KHY1, it will for sure work considering all my wiring is good. Right? 1- is there a way to modify the KHY2 to make it act as a KHY1? If not, its ok I will just replace with the KHY1. 2- the other wires that come in the box are all similar right? Only the big 6-pin connectors from KHY1/KHY2 are different?

23/08/2019

Kia Gdrover (400Pts.)

0

2010 Kia Rondo Key start Automatic door lock/unlock does not work after install Firmware 76.51

2010 Kia Rondo Key start Automatic door lock/unlock does not work after install Firmware 76.51, Remote Starter option #32 set to #5 per guide #60981. Installed Evo One, and PATS key frogramed OK, rapidly flashing yellow light. The lock/unlock fob does not work. If I disconnect the battery nd reconnect the battery the lock unlock works but Evo One does not respond. When I start the vehicle with the key and turn it back off the lock unlock stops working again This car has a seperate fob for the lock/unlock function. it is not part of the key.

22/08/2019

Kia Gdrover (400Pts.)

0

What is the Evo One bypass Firmware version for 2010 Kia Rondo Automatic Key Start

What Evo One bypass Firmware version is required for 2010 Kia Rondo, Automatic, Key Start

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer