Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

2014 Hyundai Sante Fe Evo One Lte. factory remote

Hello, I installed Evo One Lte in my 2014 Hyundai Santa Fe Sport PTS. The Evo start works great via the Cell app but i cant get the factory remote to start the car. Also, the cell app WILL NOT operate the door lock/ unlock. The list says 3 locks will start and stop remote start, but i cant get it to work. Not sure if its my fault or If factory fobs will not work on this vehicle Any help is greatly welcome !!!! THANK YOU ALL VERY VERY MUCH

1

IS there a T harness for 2014 Hyundai Sante Fe Sport Push To Start?

Hello, is there a T harness for 2014 Hyundai Sante Fe Sport Push To Start? Did not see one but wanted to double check. Thank you for your time.

0

2019 Veloster PTS Manual, Bypass wont program

2019 Veloster PTS Manual. Wire to wire according to https://fortin.ca/download/98741/EVO-ONE_IG_RTO_BI_KHY8-VELOSTER_2019_PTS_B_98741.pdf Bypass wont program when ignition is pressed twice. Any advice on troubleshooting would be greatly appreciated.

0

2018 Tucson

Hello. I'm currently installing an evo-one on a 2018 Tucson. The blue connector in the kick panel is different from the one shown in the diagram (97941). EMC com is not located there. There is a white wire in another place and it says LIN...Use this white wire?

0

2019 Veloster PTS Manual 3x Lock Evo One

Getting conflicting information from local installers. Would prefer not to have an extra remote but if need be I will purchase one. 2019 Hyundai Veloster Push to start Manual.Looking at installing an Evo-one Will the 3x lock start work? Can I set the ready mode without another remote? Any help appreciated

0

Hyundai Elantra N 2022 installation valide?

J'aimerai savoir si hyundai elantra N 2022 manuelle avec cluster numerique push to start installation valide? demarreur a distance Evo-one. Si oui de guide # 99621 ok pour l'installation?

0

2013 elantra gt

I installed an evo-one on a 2013 Elantra GT (PTS) today. The firmware says that the OEM remote will not operate while the engine is running ... But, it works normally ... It both opens and closes. What's the matter?

0

4706 viper evo-all on 19 veloster.will not fire starter wire

    19 veloster push start standard...goes into reservation but will not trigger start wire  

0

Problem for instruction installation - 2013 hyundai santa fe evo one

Is no possible to information how installing evo one to 2013 hyundai santa fe push to start- i try on ios, google chrome, opera , iexplorer ... still no succes

0

How to use the turbo timer for 2015 Hyundai Veloster? (PTS)

How to use the turbo timer for 2015 Hyundai Veloster? PTS

1

Just wondering what's the difference between THAR-ONE-KHY7 version 1 and version 2

The harness I bought says version 1. Will it work on Hyundai Tucson 2020 push to start. Instructions say to use version 2. Any help will bd appreciated.

0

2014 hyundai sante fe sport push start worked for 3 days

2014 santa fe sport worked for 3 days then when used today started but died once door was opened didnt do this prior 3 days now only cranks no start

0

EVO-ALL not receiving lock input after we had to unplug and replug in.

2018 Hyundai Elantra PTS. We had the remote start working after a little while but we realized we had a bad/loose connection from the pts button so it would not let us press the brake even after pressing the PTS button when we would get in. We diconnected the harnesses and fixed the PTS connection issue and hooked it all back up. Now when we press the lock button on the fob the blue LED doesn't light up for when it receives the lock input. When we start the car the yellow led turns on like normal. I have checked most of the connectors, the 12v is solid and the ground is solid. We got the remote start for MPC so we do not have the flasher. Is there some sort of security feature that disables it when you disconnect the harnesses? I assume the evo reads the lock input via the CAN bus's? We are kind of at a loss for now, but will probably go back and check all the connections again at some point.

0

2019 veloster push to start not working

I just installed the Evo-One with the T harness. I programed the Evo and the started the car. Followed the reservation mode and the hit the push to start button and the car shuts off! I notice that when the car is on the Evo-One only shows a orange/yellow light, that's it. Please help.

0

Is it possible to install a FTX 64-2W to remote starting at Ioniq 2019 Electric ?

I don't care if it will not activate when the vehicule is charging.

0

What wire to use evo one to connect to clutch bypass. 2019 veloster n push to start

Clutch switch has a white, red and 2 black wires on it.

0

2014 Santa Fe Push-to_Start was starting fine and than stopped.

After installing the Evo-One it worked perfectly for a day. I than installed the Pink/Black Trunk release wire to Plug D pin 3 in the fuse panel. Remote start still worked right after and than an hour later it stopped working. The remote start doesn't engage the engine when I hit the lock 3 times, I just get the 3 blue LED flashes and it doesn't go red. I checked continuity on all the wires except the can bus connections because I am getting the blue LED and they were all connected. The LED flashes blue every time I press a FOB button, and goes yellow when I turn the vehicle on. Any help would be greatly appreciated, thank you for your time.

0

2015 Sonata PTS horn wire location

Hooked up an RF kit to evo one but there's no honk when locking/unlocking and panic doesn't sound. Looks like I need to connect the horn wire from module to vehicle's (-) horn trigger, so does anyone know which wire it is for 2015 Hyundai Sonata PTS.

11/06/2020

Hyundai MM (420Pts.)

0

Hyundai Santa Fe 2020 Push start-Moteur éteint quand j'appuie sur le frein

Je vérouille les portes, je démarre le véhicule, j'essaie de déverouillé les portes mais je doit peser 2 fois sur unlock pour que les portes se déverouille. Quand j'entre dans le véhicule, j'appuie 2 fois sur le boutton start du véhicule et quand j'appuie sur le frein, le moteur s'éteint. Le module installé est un evo-one et le sn:002B04 026099

-1

2015 Hyundai Sonata EVO-ONE remote start with horn

Would like to add a horn beep when car remote starts via 3x lock as an confirmation that it worked. Do I just need to connect the A7 wire (orange/black) to the horn wire in my car??? Do I need additional programming?

0

2013 Hyundai Sonata Push to Start with EVO ALL won't start

I have a 2013 Hyundai Sonata with the push to start. I installed the EVO ALL module, programmed it with the datalink 4 programmer, and did the startup programming following the instructions. The blue light flashed showing it took the program, and I pushed tthe start button to shut it off. When I push the remote lock button three times, the car reacts like it's going to start, however, if I look at the dash from the outside, it shows the smart key missing symbol. Then The car does a long beep, then the power shuts off. I double checked all my connections. Not sure whats going on.

0

2013 Hyundai Santa Fe 2.0T, Push Start

Hi there, purchased used Santa Fe. Vehicle is equipped with E300 & EVO-ALL. Purchase of the vehicle did not come with Transmitter remotes. There is a FM antenna on the windshield. Safe to  say there was a seperate remote other then OEM.

What replacement remote can I use? Or can I program current setup to OEM key? If not, can I replace it with new RF kit?

Thank you

 

0

2017 genesis g90 coverage

will you guys be adding coverage for a 2017 genesis g90 PTS?

0

2018 kona push to start, tries to crank with remote start but won't catch, why?

0

Evo one won't crank hyundai elantra

I installed evo one in my 2017 elantra.Updated the module with flashlink updater. Activated C1,D6 and 38.2. It is programmed in the car but when press lock 3 times accesory comes on for 1 sec and then shuts off. Does not crank at all

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer