User

Service Number: 001A06368710

I have a 6 speed manual and need to hard wire the door pin cable because is not working via can bus. I am using the wire color reference document and for the door pin FL it says "Blue / Orange, Driver kick panel must connect to blue/white, Pin 8.

My questions are:

1- What does it mean to must connect to blue and white? blue and white cable at the EVO all(there is not a cable with blue and white at the evo all) or something else? or that the cable goes from blue/orange to blue/white?

2-Do you have any pictures of this wire or location of the plug for reference since it is not in the wirecolor document?

3- Will I need to connect the dome sensor/supervision for this vehicle?

Thank you for your help like always.

Evo All service# 001A06282907    Firmware 4.18

I installed the system using guide#8601. The evo all programed fine, the remotes, door lock and trunk work fine.

The tach and hood wires are not required with the evo all per fortin's guide.

I am having problems with the remote start.

I followed the fortin guide and everything was connected as instructed.

I press the remote start button on the remote and the car receives the signal to start. It flashes twice and turns on the dash cluster like is going to crank but it doesn't even try to crank. The odd thing is it turns the dash off and then on twice before giving up on the remote start process.  Is like it tries 3 times to start but doesn't crank.

Any ideas? 

I tried learning the tach, going tachless and changing the crank time but still did the same. 

UPDATE AS OF JAN. 12TH 2014:

I reseted the evo all and reprogrammed. Now the car cranks for 0.5 sec but does not start. Then it does the "dash on and off"3 times again. The remote flashes 3 times after failing to start(the error code for 3 flashes is "doors open(manual trasmissions only) but I cut the green loop inside the CM6200 module to make it automatic.

I tried increasing the cranking time to 1 and 1.5 sec. but still will not start and it only cranks for like 0.5 secs.

I did the tach learn process and was not succesful.

I think this is related to the tach and door pin wires not being connected as instructed in the guide, could it be?

Note: when I start the car with the key the yellow led on the evo all is the one on.

Thank you