Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Questions & Réponses

Consultez les questions les plus fréquemment posées et trouvez des réponses pratiques et pertinentes.

recent questions tagged: ...

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez-nous une question

0

My Remote Start Stopped Working in my G37 Sedan for the RF Controller and OEM controller

My Remote Start has been working just fine since 2017. Lost Remote Start on my oem controller and rf controller. Lock and unlock work fine. Do I need to do an update? Refresh?

0

EVO ALL Decryptor Reset

Hello would you mind resetting the decryptor limit on my EVO ALL 2020 Infiniti Q50 SN: 001A07465602

0

infiniti m35x evo all does not program

hello, I just installed an evo all in an infiniti m35x 2006, I have made all the corresponding connections but at the time of programming I find a problem, the instructions say that at the moment the blue light of the evo there is set flashing (last step) press the start button to turn off the vehicle and at that moment the blue light should turn off, but the problem is that it turns off but immediately the yellow and red light start to flash intermittently without stopping and so the evo remains all alone until I completely disconnect, what can I do, i checked the cam hight the cam low and the other connections and I notice all of them well.

0

Crimestopper TELE-connect not working

Hi there, I'm trying to install the Tele-connect to an evo-one using the T-harness on a 2006 Infiniti G35x with intelligent-Key. I'm using Guide # 33131 I've enabled the following so far but no luck.

32. mode 3

2. mode 3

8. mode 2

RF Kit Compatible has been set to "Fortin 2"

 

0

EX35 EVO-NIST1 and T-harness won't remote start without foot on brake

I have a 2008 Infiniti EX35 PTS with the EVO-NIST1 and T-harness installed for a standalone remote start system. I used the most current firmware, turned on D1 and C1 options, and the module was successfully programmed. The vehicle will not start with the 3x lock signal, it will only go to on and then acc modes. In troubleshooting, I pressed the brake pedal and then tried the 3x lock which started the car. Further, I tried switching the RL1 to RL2 connector, but this did not work. Next I put a voltmeter on the white/red wire on the brake connector harness, during the startup sequence the voltage seemed to be constant but only 11 volts and occationally dropped to 0 during the sequence. I re-installed the firmware and reprogrammed the EVO again to make sure there wasn't any issues, but it still work work. Do I have a bad EVO, harness, or something else?

0

2008 infiniti qx56 intelligent key wont remote start evo one with t harness

Will remote start when I unlock all doors before remote or when remote is in vehicle but won't remote start when all doors are locked

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer